Set the dot spacing for the final size
Dot spacing is measured in output pixels. At 300 DPI, 15 px per cell corresponds to 20 cells per inch and 10 px corresponds to 30 cells per inch. If you resize the result in a layout, the physical dot pitch changes with it. Print size comes from the pixel dimensions and intended DPI. The 2,400 px width and height limits cap an image edge at 8 in when used at 300 DPI. A tall image may be reduced in both dimensions to preserve its shape. At a fixed 5 in print width, a 1,500 px image provides 300 effective PPI, but a 750 px image provides 150 PPI. A 15 px dot pitch measures 0.05 in in the first and 0.10 in in the second. Use this relationship to compare patterns at the size you will actually print. Exporting a larger raster cannot recover detail lost in the source.
Choose which tones use more ink
With normal tones, dark parts of the artwork produce larger dots. Lower the ink strength if the dense areas cover too much of the image. Raise it when medium tones look too faint. Turn on Invert tones if lighter parts should carry the larger dots. The ink color is a single exported RGB color and the dots have partially transparent edges. Changes to color do not replace the need to check the artwork on the intended garment.
Check edges and small dots before the print run
Use a transparent PNG when shapes need to stay transparent beyond their artwork. A solid background in a JPEG may show in the dots, especially after inversion. Check the PNG at its intended physical size and ask your supplier for its minimum printable dot size. Fine dots can disappear or close up under a print workflow, particularly where white underbase, ink spread or fabric texture affect the output. The preview does not simulate those effects.
Download the PNG, then use the DTF gang sheet builder to place copies at their final size. Read the PNG preflight guide before using a new supplier, or use the free job quote calculator to estimate the full film cost.